Quantitative Comparison of REAPDOR and TRAPDOR Experiments by Numerical Simulations and Determination of H–Al Distances in Zeolites

Quantitative H–Al distances in acid sites of two zeolites with MFI and IFR framework topology were obtained by numerical simulation of ¹H{²⁷Al} rotational echo adiabatic passage double resonance (REAPDOR) experiments. A ²⁷Al offset-dependent data set yields for each resolved ¹H NMR line a corresponding nuclear electric quadrupole coupling constant of the neighboring ²⁷Al site. This information is used for analyzing a second data set for on-resonance irradiation, where the dipolar evolution time (number of rotor cycles) was varied, to yield the ¹H–²⁷Al dipolar coupling constant. Numerical simulations indicate that the REAPDOR method does not depend significantly on the polar angles, defining the orientation of the electric field gradient tensor of ²⁷Al with respect to the Al–H dipolar vector. In contrast, the transfer of populations in double resonance sequence is sensitive to these angles, and it can be thus used to measure them.     

空位在金刚石近(001)表面扩散的分子动力学模拟

用分子动力学方法模拟了空位在金刚石近(001)表面的扩散过程,研究了温度对空位扩散的影响.结果表明,当温度为1000K左右时,位于近表面第二层上的空位开始向表面运动;当温度在1400—2000K时,空位完全扩散到表面.这与实验结果和其他计算结果符合得很好.同时发现,温度为1400—1800K时,空位的扩散经历了两次迁移运动,其分别对应了均方位移图中的两个极大值.在不施加任何约束的条件下得到了空位的动态扩散路径,空位在金刚石近(001)表面的扩散势垒约为042eV.并探讨了一定温度下空位数目增多及其不同排列 关键词： 金刚石 空位 扩散 分子动力学     

基于频域方法的三维物体分层重现

基于频域方法实现了数字记录和再现三维物体离轴全息图.通过频谱对应关系求得各个面的频谱分布,使用数字滤波方法,成功地消除了零级衍射和共轭像;通过改变再现距离,分别获取了三维物体各个截面的再现像.     

Optimal design of a convergent-barrel cold spray nozzle by numerical method

A convergent-barrel (CB) cold spray nozzle was designed through numerical simulation. It was found that the main factors influencing significantly particle velocity and temperature include the length and diameter of the barrel section, the nature of the accelerating gas and its pressure and temperature, and the particle size. Particles can achieve a relatively low velocity but a high temperature under the same gas pressure using a CB nozzle compared to a convergent-divergent (CD) nozzle. The experiment results with Cu powder using the designed CB nozzle confirmed that particle deposition can be realized under a lower gas pressure with a CB nozzle.     

封闭圆内开缝圆自然对流换热的振荡特性

本文通过数值计算探讨了封闭圆内开缝圆自然对流换热的振荡特性。数值计算以整个圆为计算区域,采用了非稳态的数学模型和具有QUICK差分格式的SIMPLE算法。在相同条件下计算结果和实验结果符合很好。数值结果显示, 当几何结构一定时,Rayleigh数Ra小于某个临界值时,流动和换热处于稳态,并且关于垂直中心线对称;Ra大于这个临界值时,流动和换热是振荡的,非对称的。数值实验还表明,流动和换热出现振荡时的临界Rayleigh数Rac与开缝圆的开缝度有关,且流动和换热的振荡会出现对称振荡和非对称振荡两种情形。     

Performance and simulation of an on-board guided-wave optical processor for airborne SAR applications

This paper describes the performance and simulation of a compact integrated optical processor for the real-time reconstruction of two-dimensional images in airborne stripmap synthetic aperture radar applications. The functional behavior of the processor is explained in some detail. The design criteria are briefly given. The simulation step allowed the main processor characteristics and properties to be identified. A number of comparisons were obtained in airborne SAR mission scenarios between the predictions of the optical device and those achieved by the modern electronic digital approach, based on the wavefront reconstruction method by matched filtering.     

颗粒聚集对纳米流体强化换热影响浅析

本文采用数值模拟的方法初步研究了颗粒聚集对纳米流体强化换热性能的影响。在流体中随机生成纳米颗粒团聚状态,并对其热性能进行数值模拟,结果表明,纳米颗粒的聚集将会导致流体换热性能的下降,降低程度与纳米颗粒体积分数以及聚集程度有关。     

Numerical analysis of the Toda lattice equations

Numerical solutions to three systems of integrable evolutionary equations from the Toda lattice hierarchy are analyzed. These are the classical Toda lattice, the second local dispersive flow, and the second extended dispersive flow. Special attention is given to the properties of soliton solutions. For the equations of the second local flow, two types of solitons interacting in a special manner are found. Solutions corresponding to various initial data are qualitatively outlined.     

基于二次插值的非饱和土壤水流问题的特征差分方法及数值模拟

本文针对一类非饱和土壤水流问题,提出了基于二次插值的特征差分格式,得到了严谨的L2模误差估计.并作了数值试验,指明方法的有效性.     

Joint detection of a given number of reference fragments in a quasi-periodic sequence and its partition into segments containing series of identical fragments

The problem of joint a posteriori detection of reference fragments in a quasi-periodic sequence and its partition into segments containing series of recurring fragments from the reference tuple is solved. It is assumed that (i) an ordered reference tuple of sequences to be detected is given, (ii) the number of desired fragments is known, (iii) the index of the sequence term corresponding to the beginning of a fragment is a deterministic (not random) value, and (iv) a sequence distorted by an additive uncorrelated Gaussian noise is available for observation. It is established that the problem consists in testing a set of hypotheses about the mean of a random Gaussian vector. The cardinality of the set grows exponentially as the vector dimension (i.e., the sequence length) increases. An efficient a posteriori algorithm producing a maximum-likelihood optimal solution to the problem is substantiated. Time and space complexity bounds related to the parameters of the problem are derived. The results of numerical simulation are presented.